You can try the following tips to solve most of the speed sensor related problems in your EZGO PDS golf cart. The cart starts at normal space and slows down.These issues could be related to the speed sensor.Ī faulty speed sensor wiring, a torn speed sensor wire, a broken speed sensor magnet, or a magnet that has slipped out of place can also cause problems. Some problems that you may face with your EZGO golf cart are that the cart creeps along or slows down after starting at a normal pace. Fasten the holding clip once again and ensure that it doesn’t slip out of place.Put the new magnet in the same place from where you took out the old one.Pull the magnet out gently using the pliers.Remove the clip holding the speed sensor magnet in place.A pair of pliers can make the replacement easy. Once you have removed the speed sensor, its magnet is clearly visible and you can do the following to take out the old speed sensor magnet along with the clip that prevents it from sliding too much. The EZGO speed sensor magnet can be replaced by taking the old magnet out from behind the speed sensor and putting a new one in place. Remove the snap ring or circlip with two clips that hold the speed sensor in place, using a pair of pliers.This is usually present behind the rear tire of the golf cart on the driver’s side. Locate the speed sensor on the golf cart.The speed sensor of an EZGO TXT PDS golf cart can be removed easily by following a few simple steps as given below. Make sure that the Run/Tow switch is set to Tow mode when you do this. ![]() You will need a pair of pliers to remove an EZGO speed sensor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |